diff --git a/README.md b/README.md index 4428e43..a73938f 100644 --- a/README.md +++ b/README.md @@ -28,7 +28,7 @@ Following is a list of deliberate changes with respect to the original layout of - The RCA jacks for the audio and composite video outputs have been replaced with some that can actually be found nowadays (i.e.: those that were used on A600/A1200). This resulted in relocating R409 (whose original position seems somehow improvised anyway...). - The above allowed a couple of tracks to be added so that the left and right audio channels will be somehow mixed whenever a single output jack is connected. This was lifted from the A600. - The silkscreen for some components does not match the original one. I used the built-in KiCad footprints as-is, when available. -- The silkscreen and pitch of C303 and C304 have been made smaller so that they don't overlap. +- The silkscreen and pitch of C303 C304 and C306 have been made smaller so that they don't overlap. - Speaking about the silkscreen, I have been quite liberal with it. I have used the default KiCad font and I did not follow the original label placement one at all costs. This was since today's technology can give us a bit more resolution in silkscreen printing, and I think that is worth using for the sake of clarity. Some ground stitching vias were slightly offset to make up space for labels. - The vias inside the pads of JP10A and JP11 have been slightly offset so that they are outside the pads. - The ground fill is autogenerated by KiCad, so it won't match the original exactly. @@ -53,6 +53,8 @@ You can recover the original Video Hybrid, or you can [build a new one](https:// The solder jumpers should all be preset with the most common value. You will only need to take care of JP4 if you install only 512k chip RAM: in this case DO NOT install U32 and put a blob of solder on the center and bottom pads of both JP4A and B. +The battery holder is called BS-7 and is very easy to find. Other ones will fit just as nicely. + Good luck! ;) ## Releases