- TIO status routine always returns DVS_AUTO instead of proper status.
- DP_SEEK definition is off by 1.
- reset does not properly initialize controller, seek threads.
- bounds check accesses in get_rval and put_rval for circular registers
- extend unit tests for REGister sanity checks to include all macros
- add sanity checks for new REGister macros
- Rewrote get_rval, put_rval to support fields within arrays of structures
- REG "size" field now determines access size
- REG "maxval" field now determines maximum allowed value
Merge from v3.12
The PDP11 and VAX have length switches - B, W, and (VAX) L - to
override the default parsing of numberic display or input as words
(PDP11) or longwords (VAX CPU) or bytes (VAX byte devices).
This worked fine if every value is filled in. On the PDP11:
sim> ideposit -b 0-3
0: 1
1: 2
2: 3
3: 4
sim>
But if the user skips an input, IDEPOSIT advances by 2, not 1:
sim> ideposit -b 0-3
0: 1
1: (cr)
3: 4
sim>
This change now produces the correct behavior.
PDP-11 simulator V3.12-2
sim> id -b 0-3
0: 1
1:
2: 3
3: 4
sim>
- More robust and reasonable behaviors when NOAUTOSIZE is enabled
- Repair/extension of disk metadata when AUTOSIZE is enabled
- MediaID support when device presents it
- Automatic MTAB generation when DEVICE provides a DRVTYPE list
If autoconfigure is disabled, either explicitly or implicitly by manual
setting of an ADDRESS or VECTOR, detect devices which don't have
addresses before boot.
Historically, if a configuration file explicitly set either a DEVICE's
ADDRESS or VECTOR, autoconfiguration was immediately disabled.
This change defers disabling autoconfigure until an explicitly setting
of a DEVICE address or VECTOR actually changes what had been previously
configured by autoconfigure.
This commit extends the existing DUP11 support to add simulation for a DPV11 in DDCMP mode.
It has been tested with DECnet-VAX Phase V, which has the only host driver I know of. Note
that you may see a few CRC errors logged with high traffic levels, these are due to a couple of
bugs in the VMS driver, for which I'm looking at developing a patch.
Regression testing has been done on the DUP11 on VMS, RSX and TOPS20, which all seemed to work
as well as previously.
