Paul Mackerras b14d982011 execute: Implement bypass from output of execute1 to input ...

This enables back-to-back execution of integer instructions where
the first instruction writes a GPR and the second reads the same
GPR.  This is done with a set of multiplexers at the start of
execute1 which enable any of the three input operands to be taken
from the output of execute1 (i.e. r.e.write_data) rather than the
input from decode2 (i.e. e_in.read_data[123]).

This also requires changes to the hazard detection and handling.
Decode2 generates a signal indicating that the GPR being written
is available for bypass, which is true for instructions that are
executed in execute1 (rather than loadstore1/dcache).  The
gpr_hazard module stores this "bypassable" bit, and if the same
GPR needs to be read by a subsequent instruction, it outputs a
"use_bypass" signal rather than generating a stall.  The
use_bypass signal is then latched at the output of decode2 and
passed down to execute1 to control the input multiplexer.

At the moment there is no bypass on the inputs to loadstore1, but that
is OK because all load and store instructions are marked as
single-issue.

Signed-off-by: Paul Mackerras <paulus@ozlabs.org>

2020-01-14 22:42:50 +11:00

7.8 KiB

Raw Blame History

View Raw