Merge pull request #20 from hlovdal/add-images

Add images

Electrical/Board_002/README.md

@@ -104,6 +104,15 @@ amount of current (~120mA or more) and gets gets hot so it might
 need heatsinking, but that is an [inherent problem with all ethernet
 controlles](https://electronics.stackexchange.com/questions/52349/why-is-ethernet-so-power-hungry).
 
+# Schematic
+
+![](shield1.png?raw=true)
+![](mbus-receiver-opto.png?raw=true)
+
+# PCB
+
+None yet.
+
 -------------------
 
 <sup>1</sup> Less than 20 NOK at [Elfa

Electrical/Board_003/README.md

@@ -9,7 +9,7 @@ to a M-bus level signal. It only supports sending. Based on
 It depends on an external power source capable of delivering 25-40 Volt.
 Most DC-DC boost/step-up converter modules<sup>2</sup> should be fine for this.
 
-![](mbus_master.png)
+![](MBus_Simulator.png?raw=true)
 
 ## BOM
 
@@ -32,6 +32,15 @@ This could be accomplished by reducing the 22k resistor so that it
 draws enough current.
 
 
+## Schematic
+
+![](MBus_Simulator.schematic.png?raw=true)
+
+## PCB
+
+![](MBus_Simulator.B.Cu.png?raw=true)
+![](MBus_Simulator.F.Cu.png?raw=true)
+
 
 -------------